Dual Control Spares
U Section Dual Control Pedal Adapter Bracket This adapter is used when the vehicle control pedals are of the 'U-section' design or have very wide pedal arms making it difficult to fit the standard pedal clamp. The unit is supplied complete with cable attachment fixings as shown above when bought as a separate item (for example when moving the controls to a different vehicle).
If you know in advance that you need an adapter bracket with a new dual control kit and tell us at the time of ordering, we will replace one of the standard pedal clamps in the kit at reduced cost to you. Please see fitting instructions
If you know in advance that you need an adapter bracket with a new dual control kit and tell us at the time of ordering, we will replace one of the standard pedal clamps in the kit at reduced cost to you. Please see fitting instructions
You may also wish to view these
Dual Control ClampReplacement Standard Pedal Clamp Replacement standard pedal cable clamp for fixing assembly to driver side pedal, sold singularly, consider purchasing dual control fittings for full instructions
|
Replacement Pulley BlockReplacement Pulley Block, hinged for placement at any angle over driver side pedals. Houses the inner and outer cable
|
Dual Control Accelerator Pedal KitEver needed to take total control of your training vehicle, to get you and your pupil out of a dangerous situation? Now you can with this (add on) accelerator pedal, easy to fit and remove
|